Thank you for visiting the Pro'sKit website. If you have any question or comments, please click "Submit".
5SS-979B-HG
9SS-969-A1 (ID: 4.3mm)
9SS-969-A2 (ID: 7.4mm)
9SS-969-A3 (ID: 11.2mm)
1. Check if the unit is switched ON.
2. Check the fuse, replace with the same type of fuse if blown.
3. Check the power cord and make sure there is no disconnection.
4. Verify that the unit is properly connected to the power source.
5. Check if local voltage matches the product requirement.
Heat gun cord or heating element may be damaged, please replace a new heat gun.
Heat gun plug may be loose from the receptacle, unplug the heat gun and re-attach.
Heat gun cord or heating element may be damaged, please replace new heat gun.
Disconnect the plug and measure the resistance value between the connecting plug pins as follows. If the values of 'a' and 'b' are outside the above value, replace the heating element (sensor) and/or cord assembly .Refer to Procedures 1 and 2. If the value of “c” is over the above value, remove the oxidization film by lightly rubbing with sand-paper or steel wool the points as shown.
Shipping Instructions